![]() Lifting saddle bumpers are recommended for use when handling cold-rolled material under 0.015” in thickness, tin plate and surface sensitive materials. Urethane bumpers – Coil contact surfaces are covered with replaceable bumpers. Leg motion stops, reducing the possibility of damage to coil edge and unnecessary wear on the slip clutch. Flappers–Spring loaded pivoting flapper plates trip a limit switch after contacting the coil. Urethane body bumper reduces chance of coil damage if grab frame contacts top of coil. Tapered legs–Legs can be tapered away from the coil to allow clearance for slightly telescoped outer coil wraps, thus reducing the possibility of coil edge damage. Stack lights – Various colors are available to give visual indication to the operator when limit switches have been tripped and the grab is in position to lift the coil safely. Includes digital scoreboard readout on the grab or wireless modem to transmit data to remote devices such as printers, PCs, scoreboards, etc. Weigh-Rite™ scale system has repeatable accuracy to ± 0.1% to 0.5% of lifted load in 10 pound increments. Motorized rotation–The 350° stop-to-stop rotate drive has a ring gear and pinion driven through a motor reducer and slip clutch. Connection to the crane – Standard pin bail (above left), pull-pin, low headroom, direct reeved sheaves, sister hook, pull pin bobbin, twin hook (above right). See below for further explanation of each option. A maintenance-free geared slewing ring is housed inside the welded steel frame. The Model MR5067 has a motorized rotator capable of 340° of rotation for turning a coil to a desired horizontal axis position. Many optional features are available to adapt the coil lifter to the particular needs of your coil handling system. These coil grabs, available with capacities up to 75 tons, include replaceable, non-metallic wear bars in the frame. The lifter can be operated with cab, pendant or remote controls. Combining operating efficiency, protection of the coil, and utilization of the overhead crane system, the M5067 motorized coil grab offers the most comprehensive coil handling features. The Model M5067 motorized coil grab is one of Bushman’s signature products and is used by hundreds of metal service centers and mills. These manually operated telescoping leg coil lifters are well suited for low-duty cycle service. High strength steel load hooks are easily adjusted for coil width, making the lifter very effective for use in narrow aisles. Once the feet are in the ID of the coil, they are turned 90 degrees so they can lift the coil without damaging it or neighboring coils.įor light to moderate duty cycle operations or where motorized devices can’t be used, the Bushman Model 427 Adjustable Coil Lifter is a good choice. To remove a coil, the hooks are lowered with the feet parallel to the coils. The hooks are adjustable in two inch increments to permit handling coils of varying thickness. Bushman makes steel coil grabbers and lifters to handle the narrowest slit coils up to the largest mill coils.īushman’s narrow coil lifter can maneuver between 1″ wide coils with only a 1 ½” gap between them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |